Spare part Prices forr Maruti Suzuki

I dont have the list of MGA for the new DZIRE. But the reverse sensor is a generic product, and you can refer to the prices I have previously posted.

No it doesnt. Make sure they dont damage the seats while removing them. Sometimes, they will be harsh on the fitting part and this will cause the seat to be improperly fixed. Also, this might lead to rattles etc for which the dealer CAN refuse warranty.

This WILL affect electrical warranty. Either get it installed by dealer or else do not get this done. 

I have part numbers but no prices!

what is the cost of Ritz vdi rear bumper?

Rear bumper without primer costs Rs. 1092

Thanks. That was a quickie

Hi Sankalp,
This is tremendously helpful...
If possible could you please let me know prices for (i assume any tax is excluded)

Rear wheel bearing for:
1. Maruti Esteem MPFI (post 2000)
2. Maruti Baleno
3. Esteem A/C cooling coil
4. Esteem - water pump
5. Esteem - A/C compressor (dont which make is used by MASS - subros or denso)

For Maruti 800 (Carb, 1994):
1. Lower Arm Front
2. Tie-rod ends
3. Strut kit
4. Shock absorber
5. Brake shoes (rear)
6. headlight assembly
8. Carburettor assembly

1. Front wheel bearing for esteem - Rs. 770

2. Bearing for baleno is 1400 but that is not confirmed

3. The evaporator costs Rs. 6644. If its a different part you are referring to then tell.

4. Water pump costs around Rs. 900. Will fetch exact details in some time.

5. There are two compressor assemblies, one for nonPS version costing Rs. 18k and one for PS version costing Rs 19k. 

For Maruti 800 (Carb, 1994):
1. Lower Arm Front - Rs, 307(Suspension control arm)
2. Tie-rod ends  - Rs 118 each (there are many suppliers whose cost may vary)
3. Strut bush kit is Rs. 122 (Gabriel make) Each strut with bush kit is Rs. 1272
4. Shock absorber (Rear) - Rs. 522
5. Brake shoes (rear) Rs. 69- 83(Different types)
6. headlight assembly - Glass costs Rs. 340
8. Carburettor assembly - Rs. 5220. There is one with a purge port that costs a whopping 22k. I am not sure what that is.

Note that I have given figures from the data I have. Also, older cars have a lot of sub variants and changes were made as time flowed by. Hence, there could be a difference in the parts. They are just indicative.

Thanks Sankalp. This is really helpful.
I wanted the price for the rear wheel bearing for Esteem. One cannot replace just the bearing, the entire hub assembly has to replaced with it. Price quoted by various sources ranges from as low as 2k to 6k therefore I'm not able to decide

A rash Scorpio driver knocked off the left RVM of my WagonR(K10). The mirror is intact, but the base assembly in which the mirror was housed is broken. Any idea about the mirror assembly price ?